1. Check the box for damage. If damage is caused by shipment, it must be
reported immediately.
2. Make sure you have all the parts:
a. Gas Regulator and Hand Shower Nozzle with ON/OFF Control
b. Hardware Pack and ½” NPT to Garden Hose Adapter
3. If you are using a regular standard garden hose, please use ½” npt to connect
garden hose adapter include. Please use the sealing tape (teflon) on the threads to
avoid leaks. Also check if the screen filter from the water inlet is in place, make sure
it is cleans from any particular blocking the water entrance. Having this point done
then you are ready to attach the water input/garden hose.
4. Install gas supply in to the inlet gas pipe. Do not over tighten, this can break or
crack the inlet pipe. Make sure after tight it that inlet pipe is not moving to avoid any
gas leaking or mal-function.
5. Connect the shower nozzle to the water outlet. Make sure you used teflon and
connected by hand preasure only.
6. Install the two batteries size “d”. Look to the cap of the batteries case, it shows
how to install the batteries correctly.
7. Use the top and bottom tab of the back cover heater to suspend it from the wall.
0706
Do not use the handle to suspend. Make sure to install carefully using a backup
hrench in the gas inlet hose to avoid stress and broken gas inlet pipe.
8. Attach the gas regulator by hand pressure to avoid any broken part and make
sure the gas tank valve is off. Before hooking the gas valve connection, make sure
it is completely in the off position.
Before going to the HOW TO USE section
Attention: Make sure that around the area there are no flammables, especially
gasoline or other vapors that can ignite and there are no objects that can fall over.
The exhaust and top of the unit will be hot.
9. You will hear a series of clicks and the burner will ignite. If the burner doesn’t
ignite after 5 seconds, turn off the heater and read the "Trouble Shooting" section.
10. To ensure draining of water, after use, open the drain valve (ribbed cylindrical
stem next to the water input valve).
IMPORTANT: Ensure that the drain valve is opened and water drained from the
unit after each use to avoid internal damage to the water regulator, if the outside
1. Turn on incoming water supply ensuring that you have an adequate water
pressure, between 5-145 PSI.
2. Verify that the shower nozzle is the off position.
3. Open the gas valve on the cylinder all the way.
4. If a gas leak is detected, turn off the gas valve INMEDIATELY! Do not touch the
“on/off” switch.
5. Set the water regulator knob all the way to the left.
6. Set the gas regulator knob on the face of the unit to the half way mark.
7. Turn the “ON/OFF” switch on the bottom of the unit to “ON” (the ON/OFF switch
uses the international standard of “I” for ON and “0” for OFF).
8. Turn the spray nozzle to the “on” position.
(9 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels