Marey ECO180 Manuel d'installation télécharger pdf (Page 7)

Fix the appliance to the hanging bracket. Make sure the unit is properly secured to

the bracket (See Fig. 13).

Hold the back bracket hanger in position against the wall in the desired hanging

location. Check to make sure that the bracket is level. Mark the wall where the

mounting holes should be located. Drill holes of ¼” diameter in the marked

locations. If you are on a stud, screw the bracket directly into the wall. If you are not

on a stud, insert the plastic anchor in the hole, and secure the bracket using the

screws supplied (Fig. 10).

Remove (4) screws and washers (Fig 11) from the unit to free the front cover.

Carefully lift the front cover off the unit a few inches. Disengage the plug

connecting the front cover LCD panel to the body of the unit (Fig 12). Remove the

cover completely.

Please note: If LCD connection cable cannot be disengaged, simply set the front

cover aside and keep the cable connected.

Fig. 11

Fig. 12

Fig. 13

Fig. 10

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Marey ECO180 Manuel d'installation Page 7